|
|
|
|
To put a XrayVision button in PracticeWorks.
Right-click on a blank
area of the Other buttons in PracticeWorks Chart.
Select the Add
Button option.
Click on the User
Defined Button option.
Click on the Define
New button.
Enter XVa3 as the button
name and button label. Select
entire mouth for the Entry
made for entry. Select
Not surface related for the Surface entry option.
Click on the OK button.
The
new XVa3 button will appear in the button list area of PracticeWorks.
Right-click on the new
XVa3 button.
Select the Define
AutoLinks option.
Click on the Add
button.
Click on the Select?
button in the Respond by
section.
When asked if it will ALWAYS occur for this event, click on
the Yes button.
Select the Run
another application option.
Click on the Define
New button.
Enter XVa3
as the description.
Enter the command line
to launch the XVa3 application. Make
sure that you specify the network path to the XVa3 application if running
on a network even if XVa3 is installed on the local computer. You
will additionally need to specify the short filenames (the 8.3 format)
for the path and not fully qualified names (PracticeWorks can not handle
launching fully qualified names with spaces in them).
The parameter that follows the executable file is: /p?<LastName>,
<FirstName>::<SSN>::<PersonID>?
Note that there is a space between the ?,? and ?<FirstName>?
and that you should include the quotation marks. The 8.3 format of a directory
or file can be found by using the LongToShort_Filename utility available
on Apteryx?s utilities web site http://www.apteryxware.com/files/utilities.
Click on the OK
button.
Click on the No
button when asked if PracticeWorks should wait.
Click on the No,
always respond WITHOUT asking button.
